What is a fire batt?

  • Every seal labelled and photographed
  • BM TRADA / FIRAS-certificated contractors
  • Written price before any work
Get a price

We reply with a written price.

We use these details to reply to you. See our privacy notice.

A fire batt is a slab of dense mineral wool, often 50mm thick, painted on both faces with a grey or white fire-resistant coating. It comes in sheets about 1200 by 600 and gets cut on site with a long knife or a handsaw.

It is used where lots of different services go through one hole. Picture a riser floor with a cable tray, six loose cables and a small copper pipe all in one rough opening. A collar will not fit that. A batt cut in two halves can be pushed in round all of it, with mastic round each cable and along the joins.

Some systems use one batt, some two with a gap between, some a batt on each face of the wall. The data sheet says which, for which size of hole, for what rating.

What a batt is not: loose mineral wool stuffed in a hole, or uncoated insulation slab. They look a bit similar but are not the same product and do not carry the same test.

The photo on this page is the wrong way to do it: foam over a tray. A coated batt is what replaces it.

Pink foam blobbed over a wire cable tray where it meets the head of a pink board wall
Pink foam blobbed over a wire cable tray where it meets the head of a pink board wall
Need the holes counted and sealed?

Send the postcode, the type of building and a photo or two. We will tell you whether it needs a survey first and what the sealing is likely to cost.

Call 020 3376 6178Get a quote